Introducing the SilverFire Stainless Steel Dragon Pot! Our 6.5 liter (1.7 gallon) Dragon Pot is a must have rocket stove option (it also will work on top of our Hunter and Super Dragon stove models too!). It will provide your family with over a gallon of emergency drinking water, quickly bring a pot of water to a boil to cook pasta or noodles, or provide an adequate amount of water to sanitize your cookware.
It is the only double layer, stainless steel, & full skirted pot on the planet. Our stainless steel, double wall pot reduces cook time by 5 minutes or more, bringing 5 liters of water to a boil. This represents a 25% time reduction. It also helps to reduce emissions, fuel use, and time spent cleaning sooty pot exteriors.
This pot design is significantly safer and more efficient than cumbersome, dirty, poor quality low profile pot skirts sold with other low quality mild steel rocket stove brands! A full skirted pot is much more efficient than a pot skirt. Our fixed Dragon skirt protrudes below our Survivor cast iron cook top, so the pot is firmly seated in place and cannot fly off stove burning children or cook when stirred!
The stainless steel pot bottom is constructed with two layers of quality stainless steel for extended shelf life, unlike other lower quality thin single bottom layer skirted pots. This pot is twice the build and fit & finish of the last skirted pot design we implemented at StoveTec. Best of all there is no dirty or sooty pot skirt to loose or waste time cleaning.
Cooks also love fact the Dragon Pot skirt exterior is soot free, since soot forms under the skirt or on bottom of pot, reducing exterior pot cleaning chores. Our skirted pot is much faster boiling water for emergencies or cooking, than slow heating pasteurizers and numerous other water kettles we have tested.
It is significantly superior to pot skirts and is why we do not provide pot skirts with the SilverFire Survivor. This Dragon pot can also be used on the Hunter and Super Dragon stove models. Improve emissions, fuel use and safety with the full skirt Dragon pot! Any cook is going to appreciate the reduced time to cook having no pot skirt to scrub or keep track of!
The Dragon Pot is shipped fully assembled. The pot handles must be attached. Robust heat resistant pot handles are shipped with 4 simple Phillips head screws, along with the lid and skirted Dragon pot.
Special Note: Attached the handles by aligning Phillips head screws into fixed pot skirt imbedded pem nuts, by hand. After aligning and attaching handles finger tight, use a number #2 Phillips head driver to tighten screws only finger tight. Do not overtighten*
*Over tightening Phillips head screws with too much force will result in breaking pem nuts loose from anchor points behind skirt. In the event you make this mistake, turn pot upside down and hold pem nuts in place with a long thin 5/16″ or a 8 mm open box wrench and re-insert Phillips head screws to tighten. Long hemostats can also be used to fit in gap between pot and skirt to secure nut to receive Phillips head screw to attach handles.